[2015 Upgraded with LED Backlight] Esky® Rechargable LCD Remote Control Dog Training Shock Collar with 100 Level Shock and Vibration, US Charger Included

September 27, 2020 - Comment

Esky® – Sky of Electronics Note: 1 This collar is not wateproof.It will damage the charging mechanism in the collar if water goes into the collar. 2 The 300 range is a desired value with no interference. Many factors such as weather,terran,transmission from radio devices will affect the range. This system is most suitable for

Esky® – Sky of Electronics Note:

1 This collar is not wateproof.It will damage the charging mechanism in the collar if water goes into the collar.

2 The 300 range is a desired value with no interference. Many factors such as weather,terran,transmission from radio devices will affect the range. This system is most suitable for medium to large (weigh 25lbs–60lbs)dogs. The vibration mode is more effective for small dogs and the shock mode medium to large dogs. This system is not suitable for dogs under 15lbs.

4 To save power the collar receiver will turn off if it is unused for 4 minutes – any movement will activate it – and the transmitter will go into STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minutes. – Press the mode button for 5 seconds to activate it.

About the waterproof

– Water resistance Level: IP3(Can withstand water equivalent to 0.7 liters per minute if the lid is secured properly) The collar can be worn in light drizzles but must be removed before bathing or swimming. Please note that submerging the collar in water WILL cause damage Please contact our customer service for help.
Package includes:

– 1 x Remote Transmitter

– 1 x Collar Receiver

– 1 x Adjustable Belt

– 1 x Charger

– 1 x Test Bulb step 1. Turn on the remote. step 2.Select channel 1 or 2. step 3. Use a toothpick to poke through the reset holde of the receiver collar and press the inner button gently, Red light will begin to flash. step 4. Now you should hear the first beep from the receiver collar. Press the Y button of the remote transmitter immediately. Note: You are allowed up to 20 seconds to press the Y button when the first beep is heard. step 5. You should hear the second beep from the receiver collar now, indicating that syncing has been finished.